Yes! To aid in the release of silicone rubber from your mold box or your original, use a small amount of rubbing alcohol. The rubbing alcohol will make the cured silicone very slippery and will help separate the silicone from the other surface. After you remove the original, dry out the excess alcohol with a paper towel or dry cloth. Be sure to warm and dry out the mold COMPLETELY before pouring resin into the mold to avoid the alcohol from contaminating and affecting the resin. You can also use rubbing alcohol to assist you in removing resin pieces out of a silicone rubber mold. Use the same process as mentioned above for removing your mold from the original and the mold box. Make sure the resin is cured before putting the alcohol in the mold.